Shelving Unit Assembly 5 Shelves & 4 Posts - 30inL x 14inW x 63inH

SHELVING

• Each shelf shall be made from one sheet of heavy duty 16 gauge material with all four corners uniformly coped to exact contour to receive internal corner castings in crevice-free alignment.  The perimeter of each shelf shall have a die formed raised marine edge, 3mm high on a 7mm radius.  The lower edge of the shelf perimeter shall be hemmed and pressed light along the shelf length.  Shelves shall be shipped with set screws to allow shelves to be installed and adjusted to any desired spacing.  Shelf corner castings have a hole to take 1-1/4 O.D. shelf posts. 

POSTS

• Shall be equipped with press fit plastic caps at both top and base.  Posts shall be marked at 2” intervals to assist alignment of shelves during assembly. 

CASTERS:

• In installations where multiple corners ‘L’ or ‘U’ shaped section are required, removable adjustable clips shall be provided to rigidly support adjacent shelves, eliminating the need for corner posts and providing free storage areas at all corners.  In multiple sections, one section only shall require four posts and all adjacent sections two posts with supporting clips per shelf.  Shelves shall be delivered knocked down and packed in protective cardboard containers marked with the size and material of the contents